Prewired Throttle Bundle with Key Voltmeter and Three-Speed Switch for Aftermarket Controller Harnesses

This prewired throttle bundle brings a throttle, key voltmeter and three-speed switch together for a compatible aftermarket FarDriver controller installation. Approximately 100 cm of wiring on each component helps reduce the need for extensions, while the throttle's metal housing and potted internals provide a practical foundation for your control setup.

Match the bundle to a normal aftermarket FarDriver harness before ordering. Stock FarDriver connectors do not match, and altered Kunray harnesses require wiring changes. A normal encoder harness using one eight-pin Furukawa connector is supported; encoder harnesses using nine-pin, eight-pin and six-pin Furukawa connectors together are not compatible.

Choose the no-grip configuration, a pre-installed black waffle grip, or black grips identified by black, blue, green, yellow or red lettering. Every configuration includes the key voltmeter and three-speed switch.

Features

• Prewired throttle, key voltmeter and three-speed switch keep the main controls together in one bundle.
• Approximately 100 cm wiring on each component helps accommodate installation routing.
• Throttle construction includes a metal housing and potted internals.
• The throttle uses a 2.8 mm three-pin connection.
• The key voltmeter has a maximum reading of 120 V.
• A pre-installed black waffle grip configuration reduces grip installation work.

Specifications

• Included components: Throttle, key voltmeter and three-speed switch
• Wiring length: Approximately 100 cm per component
• Throttle construction: Metal housing and potted internals
• Throttle connector: 2.8 mm three-pin connection
• Key voltmeter limit: 120 V maximum
• Harness requirement: Normal aftermarket FarDriver harness; stock FarDriver connectors do not match
• Encoder harness compatibility: Normal harness using one eight-pin Furukawa connector; excludes primary harnesses combining nine-pin, eight-pin and six-pin Furukawa connectors
• Grip configurations: No grips; pre-installed black waffle grip; black grips with black, blue, green, yellow or red lettering
• Installation precautions: Disconnect the battery before wiring the key voltmeter. Check pin alignment and never force connectors.

Frequently Asked Questions

Does every throttle bundle include the key voltmeter and three-speed switch?

Yes. Every grip configuration includes the throttle, key voltmeter and three-speed switch, including the no-grip configuration.

Will this bundle plug into a stock FarDriver controller?

No. This bundle requires a compatible normal aftermarket FarDriver harness; stock FarDriver connectors do not match. Altered Kunray harnesses require wiring changes.

Which encoder harness can I use with this bundle?

This bundle supports a normal encoder harness using one eight-pin Furukawa connector. It does not support a primary encoder harness combining nine-pin, eight-pin and six-pin Furukawa connectors, such as the FarDriver ND961800b HR.

How do the bundle's connectors connect to the harness?

On a compatible FarDriver harness, connect the throttle to the white three-pin connector, the three-speed switch to the blue three-pin connector, the voltmeter's two-pin plug to the red two-pin connector, and its single-pin connector to the orange key-lock wire. Disconnect the battery before wiring the key voltmeter, check pin alignment and never force a connector.

How should I install grips on the throttle?

Use soapy water to slide grips onto the throttle. Avoid forceful twisting in the opposite direction because it can break the internal stopper. The pre-installed black waffle grip configuration saves this installation step.